I would like to add a Dual Motor badge to my new Juniper. Tesla provides a green template on their website, but I couldn’t find any information about the exact badge location. Could any Dual Motor Juniper owners share the alignment details (as shown in the red lines)? Thanks in advance!
![Image]()
maetorn
Dual Motor Badge Alignment
I would like to add a Dual Motor badge to my new Juniper. Tesla provides a green template on their website, but I couldn’t find any information about the exact badge location. Could any Dual Motor Juniper owners share the alignment details (as shown in the red lines)? Thanks in advance!
![Image]()
Instructions for adding the badge can be found here:
service.tesla.com
Tesla uses a jig to align the badge:
I also looked in the "service tools" section of the parts catalog, and it looks like Tesla has a different jig as well:
epc.tesla.com
And that's available through a third-party:
www.mpcmfg.com
Hopefully one of those will work for you. Or just eyeball it.
| Tesla
Correction code 1205010402 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See...
Tesla uses a jig to align the badge:
- 2091866-00-A REAR DM BADGE JIG
I also looked in the "service tools" section of the parts catalog, and it looks like Tesla has a different jig as well:
Parts Catalog
And that's available through a third-party:
1557459-00-A – MPCM, Inc.
www.mpcmfg.com
Hopefully one of those will work for you. Or just eyeball it.
I read somewhere it added 80HP. And the badges wrapped in carbon fiber reduced the cars' weight by 20 Lbs. But I've not had one so equipped on my corner scales thus I cannot verify that.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
